SMART CLEANER has been designed to dissolve oils and greases from metal surfaces, especially stainless steel, as well as to remove traces of felt-tip pen ink. Removing these deposits is essential for the success of subsequent heat, galvanizing and chemical treatments in general. It was designed to be straw-yellow so that it can easily be identified.
Instructions for use
SMART CLEANER is sold as a ready-to-use liquid, but can be diluted with water at a 1:1 ratio in volume depending on the amount of pollutants to be removed. Dilute by adding the concentrate to the water and mixing carefully. The liquid is normally sprayed on at ambient temperature.
The treatment times are in relation to the degree of dirt on the surfaces to be treated and vary from 30 seconds to 15 minutes.
Once the pieces have been degreased, thoroughly wash them using a high-pressure washer. If degreasing is the final phase, a further wash with demineralized water will ensure obtaining an optimal result.
Precautions for use
Use suitable personal protective equipment and follow the instructions on the safety data sheet.
Washing wastewater is acidic and therefore cannot be drained directly but requires neutralization and decantation.
Industrial wastewater may only be drained after authorization of the competent authorities. Delmet can supply manual or automatic equipment for this type of treatment.
SMART CLEANER degreaser is available in the following formats:
- SMART CLEANER degreaser - pack of 6 x 800g (PC01558)
- SMART CLEANER degreaser - pack of 25kg (PC01463)
- SMART CLEANER degreaser - pack of 1100kg (PC01557)